Fold Down Saddle Rack
Model CM 40

• Constructed of heavy 3/4" tubing and 1 1/4 flat bar - all assembled into a single unit.
• Extends out 24 inches in the upright position and lays flat against the wall in the down position.
• An integral bridle hook is included that can be used in either position.
• Three mounting bolt holes are provided to give complete stability.
• Enamel coated for rust prevention.

$42.00 or call 1-800-335-1880

 Western Saddles
Model CM 41

Western Saddle Racks are constructed of 1/2 inch round hot rolled steel. Welded into one piece, these models are designed for quick removal and portability. Use any place where you can install a single eye bolt (tack room, trailer, single post). The units can also be laid flat against the wall.

$36.00 or call 1-800-335-1880

 English Saddles
Model CM 42

English Saddle Racks are constructed of 1/2 inch round hot rolled steel. Welded into one piece, these models are designed for quick removal and portability. Use any place where you can install a single eye bolt (tack room, trailer, single post). The units can also be laid flat against the wall.

$36.00 or call 1-800-335-1880

 Swinging Blanket Bar for Saddle Blankets and Saddle Pads
Model CM 45

High Strength - Swinging Saddle Blanket Rack. Steel Construction with Black Enamel Coating. Strong enough to hold heavy, wet blankets and saddle pads. 3 Swinging Arms allow to position them independently . Four point mounting for stability. Each arm can be removed easily. Mounting surface is 24 inches. Arm length is 31 inches. Weight approximately 7 lbs. You are buying factory direct. MADE IN USA

$43.00 or call 1-800-335-1880